and turn it clockwise or counter clockwise to line the tabs up with the four slots (the inner valve
is shaped like a plus sign) and pull out the end of the valve.
4. Rotate the end of the valve and pull gently-each end is a plus sign, and will need to be turned to line
up and exit through the end of the hose to come loose. You will be left with this:
5. Once the valve is out, gently pull the spring off of the upper component and remove the black
ball.
6. Soak the valve, spring, and ball in warm soapy water or a solution of decalcifier and water,
rubbing the components to remove any scale.
7. While you are soaking the components, re-attach the spout with the two Torx screws and turn
the machine on, bringing it out of Stand-By mode.
8. Once the machine is ready for use, run three blank shots: put a cup under the brew head and
press the aroma setting (coffee bean/spoon) button until just the spoon is on the screen. DO
NOT insert ground coffee, just press the small coffee button. Water will brew through, and
flush out the spout area. Perform this operation three times.
9. Turn the machine back off, then remove the spout again with the Torx screwdriver.
To Next Page
Loading...
