Gaggia Sup 037RG - First-Time Use and Initial Operations; Running Initial Water Cycles; Rinse and Self-Cleaning Cycle

• 26 •• 26 •
Steady on
Steady on
Steady on
Steady on
Cyclic blinking
Using the machine for the
first time or after a long
period of inactivity.
These simple operations will make it pos-
sible to always brew excellent coee.
1 Place a large container under the
dispensing spout.
2 Before starting the procedure, check
that the following icons are displayed.
3 Select the pre-ground coee function
by pressing the “ “ button one or
more times.
Do not add the pre-ground
coee to the compartment.
The icon will appear on the display.
4 Press the button to brew a long coee.
5 Wait until brewing is completed and
empty the water tank.
6 Repeat the operations from step 1 to
step 5 for 3 times; then continue with
step 7.
7 Place a container under the steam wand
(Pannarello, if supplied).
8 Turn the selector switch clockwise to set
it to the “ ” position.
The following icon will be displayed.
9 Dispense water until the no water sig-
nal is displayed, then turn the selector
switch counter-clockwise to set it to
the “ ” position.
10 At the end, fill the water tank again.
Then the products can be brewed as
described in the following sections.
Rinse/Self-cleaning Cycle
This cycle allow rinsing the coee circuits
with fresh water.
The cycle is carried out:
• At machine start (with cold boiler)
• After priming the water circuit (with
cold boiler)
• During the Stand-by preparation
phase (if a coffee product has been
brewed)
• During the phase of activating the
stand-by mode after pressing the
“STAND-BY” button (if a coee product
has been brewed).
A small amount of water will be dis-
pensed to rinse and heat all the machine
components; during this phase the icons
blink in sequence.
Wait for the cycle to nish automatically.
You can stop dispensing by press-
ing either coffee button and/or the
“Stand-by” button.
4219-465-04381 GAG. MAN. BRERA IT-EN-DE-FR Rev.00.indd 26 14/10/2020 14:48:49