Gaggia Unica - Coffee Brew Length Customization

• 31 •
English
• Press the “ “ button again when the
amount of coffee in the cup reaches
the desired level.
At this point, the “ ” button is pro-
grammed; each time it is pressed and
released, the machine will brew the same
amount of co ee that has just been pro-
grammed.
The same operation can be repeated for
the “ “ button. When the “ “ or “ “
button is pressed twice to brew coffee,
the machine will brew double the stored
quantity.
using a key. Do not pour co ee beans
when the co ee grinder is working.
The machine lets you make slight adjust-
ments to the co ee grinder to adapt it to
the kind of co ee used.
This adjustment should be carried out by
adjusting the pin on the inside of the cof-
fee bean hopper; this pin must be pressed
and turned only with the key provided
with the co ee machine.
Press and turn the pin one notch at a time
and brew 2-3 cups of coffee; this is the
only way to notice di erences in grind.
The reference marks inside the coffee
bean hopper indicate the grind setting.
There are 5 different grind settings to
choose from with the following refer-
ences:
1 - Coarse Grind
2 - Fine Grind
Adjusting the Coff ee Length
The machine allows you to adjust the
amount of brewed coffee according to
your taste and/or the size of your cups.
Each time the “ “ or “ “ buttons are
pressed and released, the machine brews
a pre-set amount of coffee, as per fac-
tory settings. This amount may be repro-
grammed to your taste. Each button may
be individually programmed for a speci c
brew setting.
As an example, the following procedure
describes the programming of the “ ”
button, which is normally associated with
espresso co ee.
• Place a cup under the dispensing
spout.
•
Hold the “ “ button pressed for 5
seconds to enter the programming
mode; the “ “ icon will blink quickly
and the co ee will start to be brewed;
the icon will flash during the whole
co ee brewing cycle.
Blinking
quickly
1
2
OFF-Mode
The machine is designed for energy sav-
ing. The machine automatically turns o
after 60 minutes of inactivity.
Note: During the turning o
phase, the machine performs
a rinse cycle, if a co ee product has
been brewed.
Warning: When the power cord is in-
serted, the machine is in OFF-Mode.
To turn the machine on again simply press
the ON/OFF button; in this case the ma-
chine will go through the rinse cycle only
if the boiler is cold.