18
1. Check the connection and
ensure it is secure.
2. Change the temperature
sensor.
1. The connection between the
temperature sensor and wire is
not secure.
2. The temperature sensor is
damaged.
“E07” is
on the
screen.
There is a
temperature
sensor fault.
1. Check the connection and
ensure it is secure.
2. Change the heating tube.
1. The connection between
the heating tube and wire is
not secure.
2. The heating tube is
damaged.
1. Check the connection and
ensure it is secure.
2. Check if the machine is
overloaded. Switch off the
machine, and retry when the
motor becomes cool.
3. Change the motor.
1. The connection between the
motor and wire is not secure.
2. The motor is protected
because of over-heat.
3. The motor is damaged.
The motor
does not
work.
“E05” is
on the
screen.
There is a
heating tube
fault.
“E06” is
on the
screen.
MAINTENANCE INSTRUCTIONS
MAINTENANCE INSTRUCTIONS
Specification and Parameters
1200
69/74
595 X 665 X 845mm
120V, 60Hz
Water pressure (MPa)
0.02-0.8
Washing/spin Capacity (cu. ft.)
Dimensions (W*D*H)
Rated Voltage (AC V/Hz)
Rated power (W)
Weight (kg)
2.2
Note:
Data can vary from the nominal values given depending on water pressure,
water hardness, water inlet temperate, room temperature, type and volume
of load, fluctuations in the electricity supply and any extra options seleceted.
To Next Page
Loading...
