INSTRUCTION FOR USAGE
NSTRUCTION FOR USAGE
BUTTONINSTRUCTIONOFDISPLAY
The below picture is a schematic diagram of an electronic
display.
Button instruction
“Fridge” button: adjust the setting temperature of refrigerating
chamber (press down is effective).
“Freezer” button: adjust the setting temperature of freezing
chamber (press down is effective).
“Select” button: with each click (within 5 seconds), the
corresponding function icon flickers, and then switch among
quick freezing- intelligence successively (press
down is effective). No operation within 5 seconds will end.
Warning: The temperature will be set finally and
the flash will disappear without setting operation
over 5 seconds.
The LED display turns bright when the door is open. Push the
“Fridge” button. The buzzer rings. Then the refrigerating room
turns into the setting condition. The temperature patterns turns
flash and the temperature of the refrigerating room increase 1.
The temperature will recycles as “33”—“45”.
THE SETTING OF THE FREEZING ROOM
The LED display turns bright when the door is open. Push the
'freezer' button. The buzzer rings. Then the freezing room turns
into the setting condition. The temperature turns flash and the
temperature of the freezing room increase 1. It will recycle from
“5” — “-8”.
Warning: The temperature will be set successfully
and the flash will disappear if stop setting over 5
seconds.
12
F unction m ode
area display
F ri dge button
F reezer button
Sele ct button
F reez ing tempe rature
di splay
Refr ige ra ti on
te mpe ra ture di splay
THE SETTING OF THE REFRIGERATOR COMPARTMENT
To Next Page
Loading...
