Galcon DC-4S - Setting Irrigation Parameters; Setting Irrigation Duration; Selecting Irrigation Days of the Week

3. Programming the Irrigation Controller
This section describes the programming steps for a simple irrigation schedule.
It is followed by a section dealing with more advanced irrigation controller
operations.
© The irrigation controller is programmed with the aid of 4 buttons:
Programming Step Selector - used to select the desired programming
mode (e.g., clock setting mode)
© Parameter Selection Button - used to select the parameter to
be changed (e.g., hour, minute, etc.). The selected parameter can only be
changed when its entry is blinking on the display.
@) Increment Button - increases the value of the selected parameter
(e.g., when hours is selected, from 06:00 to 07:00).
© Decrement Button - decreases the value of the selected
parameter (e.g.,whenhours is selected, from 06:00 to 05:00).
3.1 Setting the Current Time and Day of the Week
To enable the irrigation controller to operate the
irrigation system at the correct times, the current | (2
time and current day of the week must first be
set.
1. Press ©) several times until the © appears.
2. Press ©) The hour digits blink. Set the current
hour using ® and © (Note the AM and PM
designations).
3. Press & The minute digits blink. Set the
current minute using ® and ©.
4. Press ®© A blinking up arrow appears at the
top of the display. Move the arrow to the current
day of the week using the @ or © button.
If the most recent data item stops blinking before you finish programming it, press ® to
continue the programming process.
9