G.S.I DC Installation and Operation Guide
30
passed for the current day, the program starts at that time the next
day.
2. Press and
to increase and decrease the number of days. In
Figure 37, the value is set to 10 days. The maximum supported
value is 30 days.
3. Press
to save the defined start day and continue to define the
start time in the Start Time screen. The default setting is OFF, which
means that the irrigation program never starts.
Figure 38: Start Time Screen
Figure 39: OFF Screen
4. Press and
to set the start time. The possible range of values is
0:00 to 23:59. Alternatively, you can cycle through the time settings
until reaching the OPEN option. Setting the start time to OPEN
causes the irrigation cycle to start immediately after you save the
start time setting (overriding the defined start day).
To Next Page
Loading...
