Gallagher Fence Control - Page 13

GE - Fence Control
- V1.1
13
SMS commands - Control
Switch on pasture fence or external device
If possible, the Fence Control acvates the energizer and starts
measuring the fence voltage. It may take several minutes
for the Fence Control to operate in normal mode
and sends alarms and alerts.
Parameter descripon
<device> ... wz or ext
(oponal)
Without parameters
Switches the energizer and the external
Switch on the switching output of the Fence Control and start the measurement.
on wz
Turns on the energizer and starts the measurement.
on ext
Turns on the external output.
Switch o the meadow fence or external device
Parameter descripon
<device> ... wz or ext
(oponal)
Without parameters
Turns o the energizer and the external switching output
of the Fence Control.
from wz
Switches o only the energizer.
from ext
Turns o external output only.
Fence Control meadow
Fence device: A
Grid voltage: 5000V
External output: On
Power supply: 11.4V
LTE: 85%
Temperature: 22 degrees C
Fence Control meadow
Fence device: O
Grid voltage: 5000V
External output: On
Power supply: 11.4V
LTE: 85%
Temperature: 22 degrees C
on <DEVICE>
to
on
o <device>