English
Gallagher 3E2488 M1200i Energizer User Manual
10
Step 3. Connect the fence
Connect the energizer’s red output (a) ) terminal to the fence using
Underground Cable (G627). Remove 5cm (2”) of plas c coa ng from one end
of the cable. Unscrew the red (FENCE) terminal and insert the wire through the
terminal slot. Screw the terminal closed, ensuring the wire is fi rmly clamped.
A ach the other end of the cable to the fence using a Joint Clamp (G603).b)
For instruc ons on fence installa on see the Gallagher Power Fence™ Manual or go
to www.gallagherams.com
Step 4. Turn the Energizer On
Plug the energizer into a power outlet and switch ON.
Check that the Power On LED on the front of the energizer is green.
IMPORTANT: Readings will change as the fence condi ons change. This is the
Energizer monitoring the fence and Energizer performance. Read the sec on
“Understanding your M1200i Energizer Controller” (p10) for a complete
understanding of the display and alarms.
To Next Page
Loading...
Need help?
General
