ENGLISH15
reversed to extend the working life,
- STRAIGHT SQUEEGEE: adjust pressure on the ground using the
screw on the mobile support, tightening lightens the pressure,
unscrewing increases pressure.
- PARABOLIC SQUEEGEE: adjust pressure on the ground by
tightening the adjustment nuts above the levelling wheels on the back
of the squeegee.
5.7. The brush motor shuts down:
- the automatic battery protection device has tripped. Stop working and
recharge the batteries immediately.
5.8. The dirty water does not drain out through the hose:
- make sure the tank is not blocked near the drain outlet.
- remove any blockages in the drain hose itself.
5.9. The machine leaves a smeary mark:
- no water flow,
- no solution in the tank (fill the tank), or solution tank filter dirty (clean
filter),
- check the brush feed pipe which could be blocked, - open the
water cock if closed.
- carry out the additional checks described in point 5.1.
5.10. The machine does not move forward or moves forward too
slowly (BF SERIES MODELS WITH DRIVE ONLY)
- check and remove any oxidation on the battery terminals, then tighten,
- the squeegee is stuck to the ground by excessive suction. See point
5.6.
- the batteries are flat, stop work and recharge.
To Next Page
Loading...