Editing Information in a Position
Report...............................................120
Deleting a Position-Report Call...... 120
Viewing Vessel Trails on the Chart 120
Individual Routine Calls...................... 120
Selecting a DSC Channel................ 121
Making an Individual Routine Call.. 121
Making an Individual Routine Call to
an AIS Target................................... 121
Gauges and Graphs...................... 121
Viewing the Gauges............................ 122
Engine Alert Icons........................... 122
Changing the Data Shown in a
Gauge............................................... 122
Customizing the Gauges................ 123
Customizing Engine Gauge and Fuel
Gauge Limits................................... 123
Selecting the Number of Engines
Shown in Gauges............................ 123
Customizing the Engines Shown in
Gauges............................................. 123
Enabling Status Alarms for Engine
Gauges............................................. 123
Enabling Some Engine Gauge Status
Alarms.............................................. 124
Yamaha Engine Gauges..................... 124
Engine Condition Icons................... 125
Engine Alert Icons........................... 126
Setting Up the Gauges.................... 126
Mercury® Engine Gauges...................128
Setting the Fuel Alarm........................ 129
Synchronizing the Fuel Data with the
Actual Vessel Fuel...........................129
Viewing the Wind Gauges...................129
Configuring the Sailing Wind
Gauge............................................... 129
Configuring the Speed Source........129
Configuring the Heading Source of the
Wind Gauge..................................... 130
Customizing the Close-Hauled Wind
Gauge............................................... 130
Viewing Trip Gauges........................... 130
Resetting Trip Gauges.................... 130
Viewing Graphs................................... 130
Setting the Graph Range and Time
Scales.............................................. 130
Disabling Graph Filtering................ 131
Battery Management.......................... 131
Setting Up the Battery Management
Page................................................. 131
inReach® Messages.....................131
Connecting an inReach Device to the
Chartplotter......................................... 131
Receiving inReach Messages............ 131
Sending an inReach Preset Message 132
Replying to an inReach Message....... 132
Digital Switching...........................132
Adding and Editing a Digital Switching
Page..................................................... 132
Garmin Boat Switch™.......................... 132
Configuring the Garmin Boat Switch
Device.............................................. 132
Using the Bilge Pump Switches..... 134
Using Dimmable Lights...................134
Controlling Third-Party Equipment
Installed on Your Boat.................. 135
Power-Pole® Anchor System.............135
Enabling the Power-Pole Anchor
Overlay............................................. 135
Setting Up the Power-Pole Anchor. 135
Power-Pole Overlay......................... 136
Enabling the Mercury Helm................ 136
Mercury Troll Control Features.......... 136
Adding the Mercury Troll Control
Overlay............................................. 137
Mercury Troll Overlay...................... 137
Mercury Cruise Control....................... 137
Enabling the Mercury Cruise Control
Overlay............................................. 137
Mercury Cruise Control Overlay..... 138
Mercury Engine Details....................... 138
Adding the Mercury Engine
Overlay............................................. 138
Mercury Engine Overlay.................. 139
Enabling the Mercury Engine Sport
Exhaust Setting............................... 139
Dometic® Optimus® Features.......... 139
Activating the Optimus Overlay
Bar.................................................... 139
Optimus Overlay Bar Overview....... 140
Optimus Overlay Symbols.............. 140
vi Table of Contents