Spd/Cad Sensor 2
9
EN
2 Twist the cover counter-clockwise until the
marker points to unlocked and the cover is
loose enough to remove.
3 Remove the cover and the battery
②
.
4 Wait 30 seconds.
5 Insert the new battery into the cover,
observing polarity.
NOTE: Do not damage or lose the O-ring
gasket.
6 Twist the cover clockwise until the marker
points to locked.
NOTE: The LED ashes red and green for a
few seconds after battery replacement.
When the LED ashes green and then
stops ashing, the device is active and
ready to send data.
Replacing the Cadence Sensor Battery
The LED ashes red to indicate a low battery
level after two revolutions.
1 Locate the circular battery cover
①
on the
back of the sensor.
To Next Page
Loading...
