PRODUCT OVERVIEW
OPERATION
For best results, please read the following:
Insert the 12V plug into a 12V 1.
automobile outlet and slide the On/
off switch forward to begin using the
Garry™ car vacuum. The red LED
power indicator will light up.
Clean the desired area of your 2.
automobile by resting the open end of
the collection container on the soiled
area and moving it back and forth in
any direction. Continue to do so until
the area is clean.
For hard to reach places like corners 3.
and between seats, attach the crevice
tool as shown in Figure 1.
Motor housing1.
Collection container2.
Container release button3.
LED power indicator4.
On/off switch5.
Crevice tool6.
Liquidtool7.
Dust lter8.
Dust lter housing9.
12V plug10.
Use the liquid tool for cleaning up spills 4.
or other wet areas. See Figure 2.
IMPORTANT NOTES: Make sure you
never exceed the maximum liquid level
marked on the side of the collection
container. Always empty the liquid
from the container before you resume
cleaning or before storing the Garry™
car vacuum.
CLEANING AND
MAINTENANCE
Please read these instructions carefully
before cleaning the vacuum cleaner:
Clean the outer surfaces of the 1.
Garry ™ car vacuum by wiping them
with a clean dry cloth.
To clean the collection container, hold 2.
the vacuum vertically. Press the
container release button with one
hand and gently guide the container
off the motor housing with the other.
See Figure 3.
Remove the dust lter housing as 3.
shown in Figure 4.
Pour the debris or liquid into an 4.
appropriate receptacle. If necessary,
hand wash the collection container with
soap and water and dry it thoroughly.
Clean the dust lter by tapping it 5.
repeatedly to remove excess dust
and dirt. Gently hand wash the lter
with soap and water if necessary.
Thoroughly dry the lter and inspect for
damage before reinstalling. If there is
damage, contact the Garry™ customer
support center. Never use the Garry™
car vacuum without the lter properly
in place.
For more information about the Garry™ car
vacuum or other available products, please
call the customer support center as shown
on the back of this page.
Figure 1
Figure 3
Figure 2
Figure 4
1
2
3
4
5
6
7
8
9
10
To Previous Page
Loading...
