The Store Menu allows you to select a sample point and either store a single sample to it or begin a log
at that sample point using the logging parameters chosen in Logging Setup.
Use the Up and Down Key to highlight the ID you wish change then press the OK Key to select it.
With an ID selected use the Left and Right Keys to change to the sample point you want then press OK.
Right Soft Key, labelled “Exit”, will exit the Store Menu and return to the Gas Display.
When you have chosen a sample point you wish to store a reading to you can press left Soft Key,
labelled “Store”, to store the current reading or press Middle Soft Key, labelled “Log”, to begin
unattended data logging (see Appendix C).
Store will store the current frozen or unfrozen reading and show a popup saying “Reading stored” and
the number of free readings available (i.e. the amount of store space remaining) if the store was
successful.
Log will take you to the Logging Display (see Appendix C) and begin unattended data logging to the
selected sample point using the parameters chosen in Logging Setup.
To Next Page
Loading...
