8 RIDING INSTRUCTIONS
20
8.1 Checks and maintenance measures when preparing for use
Info
Before every trip, check the condition of the vehicle and ensure that it is safe to operate.
The vehicle must be in perfect technical condition when it is being operated.
H02217-01
–
Check the gear oil level. ( p. 91)
–
Check the front brake fluid level. ( p. 62)
–
Check the rear brake fluid level. ( p. 70)
–
Check the front brake linings. ( p. 65)
–
Check the brake linings of the rear brake. ( p. 71)
– Check that the brake system is functioning properly.
–
Check the coolant level. ( p. 82)
–
Check the chain for dirt. ( p. 54)
– Check the chain, rear sprocket, engine sprocket, and chain guide.
( p. 56)
–
Check the chain tension. ( p. 55)
–
Check the tire condition. ( p. 78)
–
Check tire pressure. ( p. 79)
–
Check the spoke tension. ( p. 79)
Info
The spoke tension must be checked regularly as incorrect
spoke tension will strongly impair riding safety.
–
Clean the dust boots of the fork legs. ( p. 38)
–
Bleed the fork legs. ( p. 37)
– Check the air filter.
– Check the settings of all controls and ensure that they can be oper-
ated smoothly.
– Check all screws, nuts, and hose clips regularly for tightness.
– Check the fuel level.
8.2 Starting the vehicle
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation when running the engine.
– Use effective exhaust extraction when starting or running the engine in an enclosed space.
Note
Engine failure High rpm with a cold engine negatively impacts the lifespan of the engine.
– Ensure that the engine is always warmed up at low engine speeds.
Info
If the motorcycle is unwilling to start, the cause can be old fuel in the float chamber. The flammable elements of the
fuel evaporate after a long time of standing.
If the float chamber is filled with fresh fuel, the engine starts immediately.
To Next Page
Loading...
Need help?
General
