SERVICE WORK ON THE CHASSIS 11
59
11.39 Checking the link fork
F02202-01
– Check the link fork for damage, cracking, and deformation.
» If the link fork shows signs of damage, cracking, or deformation:
– Change the link fork.
Info
Always replace a damaged link fork. GASGAS Motor-
cycles does not permit repairing link forks.
11.40 Checking the throttle cable routing
Warning
Danger of accidents The throttle cable may slip out of the guide if routed incorrectly.
The throttle slide will then no longer be closed and the speed can no longer be controlled.
– Make sure that the throttle cable routing and the play in throttle cable complies with the specification.
Preparatory work
–
Remove the seat. ( p. 50)
– Turn the knurled screw on the fuel tap all the way clockwise.
–
Remove the fuel tank. ( p. 45)
F02995-01
Main work
– Check the throttle cable routing.
The throttle cable must be routed to the carburetor behind the
handlebars and above the fuel tank bracket.
» If the throttle cable is not routed as specified:
– Correct the throttle cable routing.
Finishing work
–
Install the fuel tank. ( p. 46)
–
Mount the seat. ( p. 50)
11.41 Checking the rubber grip
401197-01
– Check the rubber grips on the handlebar for damage, wear, and
looseness.
» If a rubber grip is damaged, worn, or loose:
– Change the rubber grip.
Rubber grip adhesive (00062030051) ( p. 110)
–
Additionally secure the rubber grip. ( p. 60)
To Next Page
Loading...
Need help?
General
