TUNING THE ENGINE 15
89
15.6 Removing the clutch cover
Note
Environmental hazard Improper handling of fuel is a danger to the environment.
– Do not allow fuel to enter the groundwater, the soil, or the sewage system.
Info
Fuel can emerge via the carburetor.
Capture emerging fuel using a suitable container.
– Turn the knurled screw on the fuel tap all the way clockwise.
– Lay the vehicle down on its left side.
F03032-10
–
Remove screws
1
.
–
Remove clutch cover
2
with the seal ring.
15.7 Adjusting the clutch
Preparatory work
–
Remove the clutch cover. ( p. 89)
F03033-10
Main work
–
Turn clutch basket
1
until adjusting screws
2
become accessi-
ble.
F03033-11
Condition
If there is no reference point:
–
Turn adjusting screws
2
counterclockwise to the last
detectable click.
–
Turn adjusting screws
2
clockwise by 9 clicks to the basic set-
ting.
Guideline
Basic setting of slip speed 8,700 … 9,300 rpm
Info
The springs may not be pretensioned by more than 17
clicks from the stop using the adjusting screws.
Condition
If the slip speed is too low:
To Next Page
Loading...
Need help?
General
