51
Replacing the LCD panel assembly
www.gateway.com
14 If the notebook has IEEE 802.11 wireless networking built in, carefully pull
the detached antenna cables up through the hole in the system board near
the touchpad, then carefully pull the cables away from the LED indicator
panel shielding.
15 Lift the LCD panel away from the notebook. The LCD panel assembly is
now completely detached from the notebook.
16 Place the new LCD panel assembly onto the notebook, then replace the
four hinge screws.
17 Reattach the grounding cable.
18 Thread the antenna cables through the guides on the LED indicator panel
shielding, then through the hole in the system board.
19 Plug the LCD video cable into the notebook.
Warning The connectors may catch on the system board hole. Be
careful not to break the connectors off the antenna cable.
To Next Page
Loading...
