58
Replacing Components in Your Gateway 600YG2
www.gateway.com
11 On the right side of the board where the connector is located, use a
flat-blade screwdriver to carefully pry the audio board up. Then lift the
audio board completely out of your notebook.
12 Align the new audio board’s screw hole with the hole on your notebook,
then press the board into place.
13 Replace the screw.
14 Plug the connectors for each speaker into the audio board. The left speaker
should be attached to the connector furthest from you.
15 Replace the four screws that secure the left speaker to your notebook.
16 Reassemble your notebook.
To Next Page
Loading...
