12
www.gateway.com
Replacing the hard drive in the hard drive
kit
Tools you need to complete this task:
Screws removed during this task:
To replace the hard drive in the hard drive kit:
1 Follow the instructions under “Preventing static electricity discharge” on page 5.
2 Disconnect the AC adapter and modem and network cables, then prepare the
notebook by following the instructions in “Preparing the notebook” on page 6.
3 Turn the notebook over so the bottom is facing up.
4 Remove the battery by following the instructions in “Removing the battery” on
page 7.
5 Remove the hard drive kit by following the instructions in “Replacing the hard drive
kit” on page 9.
Phillips #0 screwdriver
4 chrome 3 × 3.5 mm
(hard drive kit)
To Next Page
Loading...
