29
www.gateway.com
Replacing the cooling assembly
Tools you need to complete this task:
To replace the cooling assembly:
1 Follow the instructions under “Preventing static electricity discharge” on page 5.
2 Disconnect the AC adapter and modem and network cables, then prepare the
notebook by following the instructions in “Preparing the notebook” on page 6.
3 Turn the notebook over so the bottom is facing up.
4 Remove the battery by following the instructions in “Removing the battery” on
page 7.
5 Loosen the four captive memory bay cover screws, then remove the memory bay cover.
These screws cannot be removed.
Phillips #0 screwdriver
To Next Page
Loading...
