34
www.gateway.com
8 Move the antenna wires out of the way, then press outward on the clip at each side
of the module until the module tilts upward.
9 Pull the module out of the slot.
10 Hold the new module at a 30-degree angle and press it into the empty slot. This
module is keyed so it can only be inserted in one direction. If the module does not
fit, make sure that the notch in the module lines up with the tab in the module slot.
11 Move the antenna wires out of the way, then press the module down until it clicks
into place.
12 Reattach the black antenna cable to the connector labelled MAIN or M, then reattach
the light gray antenna cable to the connector labelled AUX or A.
To Next Page
Loading...
