40
www.gateway.com
Replacing the LCD panel assembly
Tools you need to complete this task:
Screws removed during this task:
To replace the LCD panel assembly:
1 Follow the instructions under “Preventing static electricity discharge” on page 5.
2 Disconnect the AC adapter and modem and network cables, then prepare the
notebook by following the instructions in “Preparing the notebook” on page 6.
3 Turn the notebook over so the bottom is facing up.
4 Remove the battery by following the instructions in “Removing the battery” on
page 7.
5 Remove the hard drive by following the instructions in “Replacing the hard drive kit”
on page 9.
Flat-blade driver Scribe or non-marring tool
- OR -
Phillips #0 screwdriver
Torx T8 screwdriver
4 chrome 2.5 × 2.5 mm
(hinge cover)
5 chrome 2.5 × 2.5 mm
(keyboard)
1 chrome 2.5 × 2.5 mm
Torx
(mini-PCI card)
6 chrome 2.5 × 2.5 mm
(LCD panel assembly)
2 chrome 2.5 × 2.5 mm
(LCD plug)
To Next Page
Loading...
