Gateway Solo 2100 - Page 47

User’s Guide 47
If you purchased the modem after the system, you will need to perfom a few
additional steps to enable the modem.
To enable the TelePath 28.8 modem:
1. Make sure the floppy disk drive module is installed in the modular option
bay, or connect the optional external floppy disk drive and install the
floppy drive module.
2. Once the modem has been installed, the New Hardware Found window
appears.
3. Click on the circle next to Driver from disk provided by hardware
manufac-
turer so a black dot appears in the center of that circle. The Install from
Disk window appears.
4. Insert the driver disk into the floppy disk drive module (usually designated
drive A:).
5. Type:
a:
on the command line provided, then click Ok. The Select Device window
appears.
6. Select Gateway 2000 TelePath 28.8 XJACK PCMCIA, and click Ok.
7. The modem is now enabled.
Once your modem is connected you can talk to the world, or send and
receive faxes on your system. Several on-line services are accessible via your
modem. Check your
Gateway Solo™ 2100 System CD for an OLS directory
that contains an overview of three different on-line services and registration
information.
à
See page 31.