227
Reinstalling device drivers
www.gateway.com
21 Remove Disc 1 of the System Restoration Kit, then click Yes. After the
computer starts, a message asks you to change the display resolution
settings.
22 Click OK. The Display Properties dialog box opens.
23 Select the desired color pallet from the Color palette list.
24 Slide the Desktop area slider to adjust display resolution to your preferred
setting.
25 Click Test, then click OK to make sure your settings work properly.
26 If the test screen showed properly, click Yes.
- OR -
If the test screen did not show properly, click
No and make changes to
the settings, then test again.
27 Click OK.
28 If required, go to “Reinstalling Windows NT 4.0 audio device drivers” on
page 227. Otherwise, go to “Reinstalling the Windows NT 4.0 Service
Pack” on page 234.
Reinstalling Windows NT 4.0 audio device drivers
Use the instructions in this section to reinstall the drivers that support the
audio devices in your computer.
To reinstall the Windows NT 4.0 audio device driver:
1 Make sure you ran the Windows NT 4.0 Locator utility to find the audio
device driver. For more information, see “Locating Windows NT 4.0
drivers” on page 223.
2 Place Disc 1 of the System Restoration Kit into your CD/DVD drive.
3 If the CD starts automatically, close the CD window.
To Next Page
Loading...
