Changing batteries 97
Installing a second battery
Your notebook has a modular bay that accepts a second battery. When a
second battery is installed, the system uses power from the second battery
when the main battery’s power is exhausted. The second battery charges when
the notebook is connected to AC power.
To install a second battery:
1 Shut down your notebook, close the cover, and turn your notebook over.
2 Slide the module bay latch and pull the module straight out.
Warning Danger of explosion if battery is incorrectly replaced.
Replace only with the Gateway Solo 9300 Li-Ion battery.
Discard used batteries according to the manufacturer’s
instructions.
The battery used in this device may present a fire or
chemical burn hazard if mishandled. Do not disassemble,
heat above 100°C (212°F) or incinerate. Dispose of used
battery promptly. Keep away from children.
To Next Page
Loading...
