138 Using the Solo Port Replicator
4 Press down on the release latch until it snaps into place.
To separate the notebook from the replicator:
1 Click Start, then select Eject PC.
2 Lift the release latch on the replicator until the notebook is disconnected
from the docking connection on the replicator.
3 Lift the notebook away from the docking posts.
Important The notebook may detect additional devices and add
drivers after being attached to the port replicator. This
process must be completed for components to work
properly. Follow any on-screen instructions, if necessary.
To Next Page
Loading...
