Gateway Solo 9500 - Changing 3.5-Inch Bay Modules

160
Chapter 12: Upgrading Your Notebook
www.gateway.com
Changing 3.5-inch bay modules
To change 3.5-inch bay modules:
1 Turn off the notebook (do not go to Hibernate mode), close the cover,
and turn the notebook over.
2 Remove the security screw (Solo 9500 only).
3 Slide and hold the release latch, then pull the module straight out and
away from your notebook.
4 Push the new module straight into the bay until it clicks into place.
5 Replace the security screw (Solo 9500 only).
6 Turn on your notebook and resume your work.
Security screw
(Solo 9500 only)
3.5-inch
modular bay
release latch
3.5-inch
modular bay