The RT2 antenna is designed as measurement and detection unit for Gatso
System solutions.
This tracking radar operates in the K-band and uses modulation to detect range
and speed to the target in the radar beam.
As part of a system, the RT2 is connected by one cable only. It provides both
power and control from the system to the RT2. The control interface is designed
on CANopen communication. The physical interface is performed by a CAN
network. The system is in command over the radar and it will perform the RF
settings when the system becomes operational.
In this manual, both power supply and control set will be described in the
following paragraphs.
To Next Page
Loading...