G A UI
T AI SHIH HOBB Y CORPOR A TION
G A UI
T AI SHIH HOBB Y CORPOR A TION
P.11
M3 x 3
10A
10B
10B
10A
機頭方向
Nose Direction
No.1
No.2
No.3
No.4
機身製作
機身製作
螺旋槳並非垂直向上，它應該呈現6度偏角(如下圖所示)。
用機鼻將螺旋槳固定在轉接頭上，並用螺絲將轉接頭鎖在馬達軸心的平面上(注意：1及3為逆時鐘旋轉
用10A槳，2及4為順時鐘旋轉用10B槳，不可裝錯.。
貼上辨識前方的貼紙
Main Frame Assembly
The propellers after installation is not totally horizontal, this is normal, the deviation / tilt is
about 6 degrees (see drawing).
Main Frame Assembly
Use the Spinner (bullet shaped part) to install the propeller on the propeller adaptor (threaded).
Tighten the propeller set onto the motor shaft (Attention: Motor 1&3 spins counter-clock-wise
and use 10A propellers. Motors 2&4 spins clockwise and use 10B propellers). Correct
propeller installation is needed for flight.
Put on Yellow Labels to
indicate Nose Direction (1 & 4).
To Next Page
Loading...