Gauzy LC6 FLEX Controller - Page 22

22
The following values should be sent to the specific DMX address ID, in order
to control the
On-O:
• Turns O (Opaque):
(Bin): 00000000 = (Hex): 0x00
• Turns On (Transparent):
(Bin): 00000001 = (Hex): 0x01
Dimmer:
• Stops the dimming output level at the moment you sent the command:
(Bin): 00000000 = (Hex): 0x00
• Dimming On (Transparent) the output level
(Bin): 00000001 = (Hex): 0x01
• Dimming O (Opaque) the output level
(Bin): 00000010 = (Hex): 0x02
• MUTE the output level. When activating the MUTE interface, the output
level will instantaneously toggle into opaque state. When deactivated, the
output level will return to the previous transparency state before Mute was
applied. (Bin): 00000100 = (Hex): 0x04
Open Interface: (Transparency percentage):
Commands in Hex:
• 000 – Output level will be 0% transparency
• 023 – Output level will be 23% transparency
• 050 – Output level will be 50% transparency
• 067 – Output level will be 67% transparency
• 100 – Output level will be 100% transparency
DMX