24
A simple command is defined to control of the output channel value: H
<channel status> For example:
On-O:
• H0 - Turns O (Opaque): the output channel
• H1 - Turns On (Transparent): the output channel
Dimmer:
• H0 - Stops the dimming output level at the moment you sent the command
• H1 - Dimming On (Transparent): the output channel
• H2 - Dimming O (Opaque): the output channel
• H4 - MUTE the output channel. When activating the MUTE interface, the
output level will instantaneously toggle into opaque state. When deactivated
by “H0” command, the output level will return to the previous transparency
state before Mute was applied.
Open Interface: (Transparency percentage):
• H000 – Output level will be 0% transparency
• H023 – Output level will be 23% transparency
• H050 – Output level will be 50% transparency
• H067 – Output level will be 67% transparency
• H100 – Output level will be 100% transparency
DMX
To Next Page
Loading...