Need help?Do you have a question about the gaviota Aland and is the answer not in the manual?
Minimum width with two lateral premium arms for awning installation.
Determines the correct placement of wall supports for the awning.
Table for adjusting component dimensions based on awning specifications.
Details on installing awning supports between walls.
Information regarding the motor support assembly.
Specifies the allowable tilt range for the awning against a wall.
Specifies the allowable tilt range for the awning against a ceiling.
Instructions for wall and central support installation.
Details on installing awning supports between walls.
Instructions for ceiling support installation.
Attach the frontal profile to the box profile.
Roll canvas, insert caps, and place assembly on box profile.
Place mat in upper profile, adjust wedges for spacing.
Attach and tighten the upper profile to the box.
Select groove based on desired angle from available ranges.
Instructions for installing the motor and related supports.
Place pieces on the pivot side of the tube in the specified order.
Assemble the invisible premium arms and connectors.
Insert canvas into charge profile and attach connectors.
Attach coverboard assembly to the fixed box supports.
Attach the coverboard profile to the wall.
Tighten plates limiting vertical and horizontal movement.
Adjust box tilt and tighten fixed supports.
Adjust elbow height for perfect box closure.
Assemble all the protective covers.
Assemble arm stoppers, aligning them with the elbow.
Procedure for axis removal during arm disassembly.
Steps for safely disassembling the motor from the support.
Recommended caps for the awning fabric tubes.
Compatible systems and components for the awning.
Description of the round pivot support with ball bearing.
Details on the motor support for manual override.
Exploded view showing components for coverboard installation.
View of the assembled coverboard unit.
Break the top shim on the coverboard parts using pliers.
Insert rubber into the back of the coverboard profile.
Attach coverboard profile supports to the main profile.
Insert front rubber into coverboard profile and cover.
Attach coverboard assembly to the fixed box supports.
Attach the coverboard profile to the wall.
Place the side covers onto the awning box.
General| Brand | gaviota |
|---|---|
| Model | Aland |
| Category | Accessories |
| Language | English |
To Next Page