GBC Modular MP2500iX - Page 46

46
TROUBLESHOOTING - MP2500iX
SPECIFICATIONS - MP2500iX
Problem
No power, won’t punch
Punches too many holes
Noisy during the last half of the punch cycle
Probable Cause
Power cord not attached to back of machine or not properly
plugged into the wall
Chip tray full. Empty chip tray with power on
Die Set is not fully inserted
Selectable pins have not been pulled
Remove the die set; press down on the top rail to push the pins
all the way through the die set revealing the ends of the pins.
Holding the die in this position, wipe the pins with a slightly oily
cloth or your thumb and forefinger.
Punch Operation
Dimensions
Weight
Shipping Weight
Electrical
Max. Sheet width
115V Machines
Operation by either one-step pneumatic foot
pedal or table top palm switch
18"(W), 8 1/2" (H), 16" (D)
51 lb.
59 lb.
115V, 60 Hz, 1.6 Amps
Open Throat
230V Machines
Operation by either one-step pneumatic foot
pedal or table top palm switch
457 mm (W), 216 mm (H), 406 mm (D)
23.3 kg
26.9 kg
230V, 50-60 Hz, 1.1 Amps
Open Throat
DIE SET INFORMATION
PB 19/21 Plastic Bind 25 A4 21
4:1 GBC Color Coil 4:1 (.2475 pitch) 17 A4 47
3:1 Twin Loop Wire 3:1 22 A4 34
2:1 Twin Loop Wire 2:1 20 A4 23
2-4/3-5-7 Loose Leaf Die Set 25 A4 11
VB VeloBind 29 A4 12
SB SurBind 29 A4 10
Die Set
Punch Pattern
Maximum Punch
Capacity*
Maximum Punch
Length, One Cycle
Total Number
of Punch Pins
*20 lb. /80 gram bond paper per punch