About storage drawer and cover removal.
Not all features are on all models.
Drawer and Cover Removal
Drawers can be removed easily by grasping
tile sides and lifting up slightly while
pulling drawers past tile stop location.
Full-Width Drawer with Plastic Cover
Toremovethecover, lift it of?["its supports,
pull it forward, tilt it and take it out.
Twin Drawers with Glass Cover
Toremove:
[]Remove the drawers.
[]Reach in, push the front of glass
cover up, and at the same time,
pull it forward as far as it will come.
Tilt it and take it out. Avoid cleaning the
cold glass cover with hot w-ater because
the extreme temperature difference may
cause it to break.
[]Remove the drawer frame. (Always
remove the glass cover before you
take out the drawer frame.)
Lift the frame off the supports at each
side and back, pull it forw-ard, tilt it and
take it out.
Toreplace:
[]Lower the frame until it rests on the
supports at each side and back.
[]Replace the glass corm; pushing its
rear edge firmly into the rear frame
channel and gently lowering tile front
into place.
[]Replace the drawers.
10
To Next Page
Loading...
Need help?
General
