About the freshfoodcompartmentshelves.
Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models.
Half-Width Shelves
One end of the shelf rests on a molded
side-wall support; a bracket on the other
end hooks into a track on the rear
cabinet wall.
TOremove, liR the shelf up at front, then
off the support and out of the track.
NOTE:Theshelf to therightof the trackis
oeslgnedto hookinto the@t-hand slot,
rneshelf tothe left is designedtohook
intothe left-handslot.
TOreplace, select desired shelf height.
With shelf front raised slightly, hook the
bracket's top lug into the track, then
lower the shelf onto the support.
Full-Width Shelves
Some models have a steel wire sliding
shelf, a stationa_ T tempered glass shelf or
two steel wire stationary shelves. These
shelves can be moved to another place
in the fi'esh food compartment.
The full-width sliding shelf has stop-locks.
When placed correctly on the shelf
supports, the shelf will stop before coming
completely out of the refrigerator and will
not tilt when you place food on it or
remove food from it.
Toremovethe full-width shelves, lift the
rear of the shelf and pull forward.
Toremove a full-width shelf when the fresh
food compartment door cannot be opened
fully, lift the rear of" the shelf, pull
forward and down, tilt the shelf and
take it out.
8
To Next Page
Loading...
Need help?
General
