GE 90*-30 PLC Series - Page 179

GFK-0356Q 8-1
Option Modules
This chapter provides an overview of Series 90-30 Option modules. For detailed information, the
applicable user’s manual should be consulted (these manuals are listed for each module at the end
of its section).
Third-Party Option Modules and the Accompany Program
In addition to the modules discussed in this chapter, numerous third-party option modules (and
other hardware and software products) for the Series 90-30 PLC are available to meet a wide
variety of needs. Third-party companies that m
eet GE’s standards may apply for recognition
under th
e GE Accompany Program. Details on the Accompany Program are found in the
GE
Solutions Catalog or on the GE web site, both listed below. For
information on third-party modules, consult the following:
 You
r GE PLC distributor or sales engineer
 The GE
web site at
http://www.ge-ip.com
Option Modules Discussed in this Chapter
 IC693CMM301 Genius Communications Module (GCM)
 IC693CMM302 Enhanced Genius Communications Module (GCM+)
 IC693BEM331 Genius Bus Controller (GBC)
 IC693BEM340 FIP Bus Controller (FBC)
 IC693BEM330 FIP Remote I/O Scanner
 IC693APU301/302 Motion Mate Axis Positioning Module (APM)
 IC693DSM302 Motion Mate Digital Servo Module (DSM302)
 IC693DSM314 Motion Mate Digital Servo Module (DSM314)
 IC693APU300 High Speed Counter (HSC) Module
 IC693BEM320 I/O Link Interface Module
 IC693BEM321 I/O Link Master Module
 IC693APU305 I/O Processor Module
 IC693CMM321 Ethernet Interface Module
 IC693PCM300/301/311 Programmable Coprocessor Module (PCM)
8
Chapter