6 RELIAGEAR® SB SWITCHBOARDS
—
02
—
02
Lifting hooks as installed
—
03
—
03
Lifting the switchboard
with a crane or hoist
Caution: The weight of the switchboard can vary.
Check the weight of the section against the
capacity of the crane when lifting.
Observe the following points when lifting the
equipment:
• Do not pass cables or ropes through support
holes
• Always use load-rated, inspected, and approved
shackles or safety hooks to attach hoisting
equipment to the lifting points.
• Rig slings so that the legs are no less than 45°
from horizontal, as shown in Figure 3
Crane / Hoist
45° minimum
Lifting slings, spreaders, blocking, and other lifting
equipment is not included with the switchboard.
CAUTION
To Next Page
Loading...
