GE AKTA avant - Connect the System Units

4.2.2 Connect the system units
Introduction
The following interconnections must be made:
•
power supply to the ÄKTA avant instrument
•
power supply to the computer equipment
•
network connection between the computer and the ÄKTA avant instrument
WARNING
•
Power cord. Only use power cords with approved plugs deliv-
ered or approved by GE.
•
Supply voltage. Before connecting the power cord, make sure
that the supply voltage at the wall outlet corresponds to the
marking on the instrument.
Connector illustration
The following illustration shows the location of the connectors.
123
ÄKTA avant Operating Instructions 29101556 AB 69
4 Installation
4.2 Hardware installation
4.2.2 Connect the system units