5.9.3 Monitor the run
Introduction
You may follow the on-going method run in the System Control module. The current
system status is shown in the System state panel in the Run Data pane. For example,
it may state Run, Wash or Hold. The same information is also shown in the instrument
display.
•
Selected curves are shown in the Chromatogram pane.
•
All registered actions during the run are displayed in the Run Log pane.
•
The current flow path is shown in the Process Picture pane.
For details on the System Control interface, see UNICORN System Control Manual.
Monitor the run
To interrupt a method during a run you may click the Hold, Pause or End buttons in
System Control. A held or paused method run can be resumed by clicking the Continue
button. See the following table.
then...If you want to...
click the button.
temporarily hold the method, with current
flow rate and valve positions sustained
click the button.
temporarily pause the method, and stop all
pumps
click the button.
Note:
An ended method cannot be resumed.
resume, for example, a held or paused
method run.
click the button.
permanently end the run
When ending a method run in advance, it is possible to save the partial result.
Note:
ÄKTA avant User Manual 29035184 AE 233
5 Operation
5.9 Create a method and perform a run
5.9.3 Monitor the run
To Next Page
Loading...
