5.2 Prepare the flow path
Introduction
The flow path is defined by the user and may contain tubing, valves, pumps and monitors.
This section gives an overview of a flow path and describes how to prepare the flow
path before a run.
CAUTION
Fasten bottles and cassettes. Always fasten bottles and cassettes
to the rails at the front and side panel. Use appropriate holders for
bottles. Shattered glass from falling bottles may cause injury. Spilled
liquid may cause fire hazard and personal injury.
CAUTION
Max. weight on Buffer tray. Do not place containers with a volume
of more than 5 liters each on the Buffer tray. The total allowed
weight on the Buffer tray is 20 kg.
CAUTION
Avoid spillage and overflow. Make sure that the system is prepared
according to the settings in the method to be run. For example
make sure that the waste tubing is inserted in an appropriate waste
container and secured in place.
CAUTION
Avoid spillage and overflow. Make sure that the waste tubing is
inserted in an appropriate waste container and secured in place.
104 ÄKTA pure Operating Instructions 29022997 AF
5 Prepare the system for a run
5.2 Prepare the flow path
To Next Page
Loading...
