4.2 Hardware installation
Introduction
This section describes the unpacking and installation procedures for ÄKTA pure.
WARNING
Protective ground. The product must always be connected to a
grounded power outlet.
WARNING
Power cord. Only use power cords with approved plugs delivered
or approved by GE.
WARNING
Access to power switch and power cord with plug. Do not block
access to the power switch and power cord. The power switch
must always be easy to access. The power cord with plug must
always be easy to disconnect.
In this section
This section contains the following subsections:
See pageSection
704.2.1 Unpack the instrument
764.2.2 Install the computer equipment
774.2.3 Connect system units
804.2.4 Install waste tubing
834.2.5 Prepare the pump rinsing system
68 ÄKTA pure Operating Instructions 29022997 AF
4 Installation
4.2 Hardware installation
To Next Page
Loading...
