ActionStep
Ensure that the path to this location appears in the Location field.7
Select the OK button to save the added location. The Cancel button will leave
the view without saving changes.
8
Remove save location
Follow the instructions below to remove a location for files saving.
ActionStep
Select the settings icon in the top right hand corner of the screen.1
Select the Save locations button.2
Select the location you wish to remove from the list.3
Select the Remove button.4
Confirm removal by selecting the Yes button.5
Edit save location
This table describes how to edit a location for files saving.
ActionStep
Select the settings icon in the top right hand corner of the screen.1
Select the Save locations button.2
Select the Edit button.3
If desired, edit the name for the save location in the Name: field.4
If desired, edit the folder for the save location by selecting the Browse button
next to the Location field.
Note:
The network settings must be properly configured before a network folder
can be added as a location for saving files. For information on how to configure
a network, see Section 4.4 Network, on page 89.
5
170 Amersham Imager 680 Operating Instructions 29271308 AB
5 Operation
5.7 Save and manage image files
5.7.1 Save locations
To Next Page
Loading...
