ActionStep
Select the Save button to save the added values and to return to the MW
Calibration view. Select Cancel to leave without saving changes.
5
Edit a marker
ActionStep
Select the Edit button.1
Result: The following view appears.
Select the value from the list. The marked values are highlighted.2
Type a new value, and select the Add button.3
Result: The new value will appear in the list.
Note:
You may need to scroll to see the new value.
Select the Save button to save the edited values and to return to the MW
Calibration view. Select Cancel to leave without saving changes. Delete will
delete the entire marker group.
4
To delete a value, select the X next to the value.
Note:
194 Amersham Imager 680 Operating Instructions 29271308 AB
5 Operation
5.8 Analyze the image
5.8.4 Molecular weight assignment
To Next Page
Loading...
