GE Amersham Imager 680 - 8.3 Problems with the software

8.3 Problems with the software
This section describes possible causes and corrective actions for problems with the
software. If the problem persists after taking the suggested corrective action, contact
your GE representative.
After exposure, no image is
displayed on the screen
Then...If...
Contact your GE representativeThe light source does not function prop-
erly
Check the sample positionThe sample is not in position
The screen of Amersham Imager
680 is not displayed on the
connected tablet computer
Then...If...
Contact the network administrator or
connect a monitor, mouse and keyboard
directly with a cable
Wireless access points are not properly
set
The buttons do not appear on an
external monitor
Then...If...
Use monitors with SVGA resolution or
higher
The monitor resolution is too low
240 Amersham Imager 680 Operating Instructions 29271308 AB
8 Troubleshooting
8.3 Problems with the software