GE Amersham Imager 680 - Date and Time

4.3.1 Date and time
Date and time view
The following illustration describes the Date & Time view.
FunctionPart
Cancel button: Use the button to return to the Settings window without
saving the changes.
1
Date field: Use the plus and minus buttons next to Year, Month, and Day
to set values for year, month, and day.
2
Time field: Use the plus and minus buttons next to Hour and Minute to set
values for hour and minute.
3
Ok button: Use the button to save the changes to date and time and return
to the Settings window.
4
Change date
To change the date setting on the instrument, select the plus or minus buttons next to
the Year, Month, and/or Day field, to change the value of year, month or day.
Amersham Imager 680 Operating Instructions 29271308 AB 79
4 Installation
4.3 System settings
4.3.1 Date and time