ActionStep
Connect the network cable to the Ethernet port on Amersham Imager 680.1
Check the DHCP radio button in the Network window.2
If desired, check the Workgroup field and use the keypad to enter the
workgroup.
Note:
For detailed information on how to use the keypad, see Keypad view, on
page 67.
3
Select OK.4
Result: An automatic connection to the DHCP network is established within
a couple of seconds.
Tip:
Reserve the IP address to Amersham Imager 680 for easier access of its net-
work resources.
Connect to a Static IP network
Follow the instructions below, to connect to a Static IP network:
ActionStep
Connect the network cable to the Ethernet port on Amersham Imager 680.1
92 Amersham Imager 680 Operating Instructions 29271308 AB
4 Installation
4.4 Network
4.4.1 Network setup
To Next Page
Loading...
