GE Amersham Imager 680 - Instrument Access from Network

4.4.3 Instrument access from network
Amersham Imager 680 is equipped with a web tool which allows instrument access from
a network. The web tool can be used to copy or delete files on the instrument from a
remote location.
To be able to access Amersham Imager 680 web tool the following conditions must be
fulfilled:
•
The instrument and the computer must be connected through a local network.
•
The instrument's IP address must be known.
Your instrument's IP address is found in the Network view. Open the view by selecting
the settings icon in the top right-hand corner and then select the Network button in the
Settings view.
DHCP networks has a dynamic IP address assignment, therefore the IP address
may vary between connections. When using a DHCP network connection,
check regularly that the IP address is still accurate. If the IP address has
changed, use the new IP address in the Network view.
Note:
Access the web tool
Follow the steps below to set up and access files via the web tool.
ActionStep
Open the computer's web browser.1
96 Amersham Imager 680 Operating Instructions 29271308 AB
4 Installation
4.4 Network
4.4.3 Instrument access from network