AquaTrans™ AT600 User’s Manual 13
Chapter 2. Clamp-On Fixture and Transducer Installation
2.1.1 Transducer Spacing = 32 to 250 mm or 50 to 320 mm, Traverses = 2, Fixtures = 1 (cont.)
5. See Figure 14 below for an example of a completed installation. In this drawing, LSL is the Lower
Specified Limit and
USL is the Upper Specified Limit for the installation.
Note: For a one-fixture installation,
LSL is 0 on the scale and USL is 250 mm for a 2 MHz transducer or 320 mm
for a 1 MHz or 0.5 MHz transducer. The transducer spacing is measured from
LSL to a point USL.
Figure 14: Installation for 2 Traverses with 1 Fixture
6. Your clamp-on fixture and transducer installation is now complete. To wire your AT600 flow meter,
proceed to “Wiring the AT600 Electronics” on page 23.
UPSTREAM DOWNSTREAM
Spacing
LSL USL
To Next Page
Loading...
