GE AquaTrans AT600 - Units Setting

Chapter 4. Initial Setup and Programming
44 AquaTrans™ AT600 User’s Manual
4.5.2 Units Setting
To check or change velocity flow units, use the [] or [] arrow key to
select
Units Setting and press []. The following screen opens.
Under
Units Setting menu, use the [] or [] arrow key to select the unit
that need to be changed and press [√] to open the following screen.
Note:
Velocity is shown here as a typical example.
If you don’t want to change the selected unit, select
No and press []. If
you do want to change the selected unit, select Yes, then press
[] twice to
open the following screen.
If no change is desired, press
[] twice to return to the Units Setting menu.
To change the measurement system, select the desired option, press
[]
twice to open a screen similar to the following.
Confirm the selected units, press
[] three times to return to the Units
Setting
menu.
User Preference
Settings
Units Setting
Density
Password
Units Setting
Velocity
Act Volumetric
Std Volumetric
Mass
UnitsSet / Velocity
No
Yes
UnitsSet /Velocity
English
Metric
Vel /
Ft/s